Roof Repairs in Headcorn& Surrounding Areas
From a single slipped tile to flashing, ridge and gable end repairs, we find the actual cause of the problem and fix it: no upselling, just the work your roof needs.
- Tile and slate replacement
- Flashing repairs and repointing
- Ridge and gable end repairs
- Clear advice on what needs doing, and what doesn't
- 18 years in the roofing trade
- Rated 9.56/10 on Checkatrade
- Open 24 hours, with emergency repairs typically within 2 hours
- Honest advice and clear quotes
- Public liability insured
- Family-run, with honest advice and no hard sell
Service overview
What Roof Repairs Involves
Roof repairs cover everything short of replacing the whole roof: slipped, cracked or missing tiles and slates, failed flashing, loose or broken ridge and hip tiles, deteriorating mortar, damaged verges and gable ends, and leaks around valleys, chimneys and roof lights. A good repair finds the actual source of the problem and fixes it properly, so you're not calling someone back out every winter.
Repairs are for homeowners whose roof is basically sound but has a specific problem. You might have spotted a tile on the lawn, a damp patch on a bedroom ceiling, daylight in the loft, or mortar crumbling off the ridge. You might have been told you need a new roof and want an honest second opinion. Often a targeted repair is all that's needed.
Professional help matters because the visible symptom is rarely the whole story. A damp patch can be caused by a cracked tile, but also by failed flashing, a blocked valley, a displaced underlay or condensation. Customers repeatedly tell us they value honest, helpful advice on which repairs are needed, and that we never push work that isn't.
The cost of waiting
What Happens If It's Left
A small roof defect rarely stays small. A single slipped tile lets water onto the underlay; a cracked ridge lets wind get under the tiles beside it. Left through a winter, a job that would have taken an hour can turn into a section re-roof.
Leaks that spread
Water finds its way along battens and rafters, showing up far from the original defect.
Damp and mould
Wet insulation and plaster lead to damp patches, peeling paint and mould inside the home.
More tiles lost
Each gap gives the wind a way under neighbouring tiles, so storm damage escalates.
Bigger bill
Rotten battens or timbers mean more extensive, more expensive work.
Common mistakes homeowners make
- Ignoring a single slipped tile because 'it's only one'.
- Paying for a new roof when a targeted repair would have done the job.
- Using sealants or tape on tiles and flashing, which traps water and fails quickly.
- Choosing whoever is cheapest without checking reviews; poor repairs are one of the most common reasons we're called out.
How it works
Our Process, Step by Step
- 01
Get in touch
Call or request an estimate. We respond quickly.
- 02
Inspection
We look at the roof and find the real cause of the problem, not just the symptom.
- 03
Straight advice and quote
We explain what needs doing, and what doesn't, and give you a clear, no-nonsense quote.
- 04
The repair
We carry out the agreed work promptly and to a proper standard.
- 05
Tidy-up and warranty
We clear up afterwards and explain the warranty terms that apply to your repair.
Why it's worth it
What You Get
Cost savings
Fixing the actual cause now avoids repeat call-outs and bigger damage later.
Longevity
A proper repair can add years to a roof that's otherwise in reasonable condition.
Honesty
Reviewers repeatedly mention honest advice and no unnecessary extra work.
Reliability
18 years of hands-on experience on Kent roofs.
In detail
A Closer Look at Roof Repairs
Tile and slate repairs
Pitched roofs in Kent are mostly covered in clay tiles, concrete tiles or natural slate. Clay plain tiles are common on older cottages and period properties; concrete interlocking tiles on many post-war homes; slate on Victorian terraces. Each fails differently. Clay tiles can crack with frost and the nibs that hook them to the battens can snap. Concrete tiles are heavy and durable but their surface wears. Slates slip when the nails holding them corrode, known as nail fatigue.
The repair method depends on the material. Individual tiles can usually be lifted and replaced, with matching reclaimed or new tiles sourced where possible. Slipped slates can be refixed with clips. Where a whole area has widespread nail fatigue or broken battens, a partial strip and relay of that section may be the sensible option.
Flashing repairs and repointing
Flashing is the weatherproofing at the joints, where the roof meets a chimney, a wall, a dormer or a roof light. Lead is the traditional material and, fitted properly, it lasts a very long time. Problems come when it's lifted by wind, cracked by movement, or when the mortar holding it into the brickwork has crumbled away. Flashing repair and repointing is one of the most common jobs we do and one of the most common causes of leaks around chimneys.
Ridge, hip and verge repairs
The ridge tiles along the top of the roof and the hip tiles on its angled edges are traditionally bedded in mortar. Over time that mortar cracks and washes out, the tiles loosen, and wind and rain get underneath. Verges, the edges of the roof at the gable ends, suffer in the same way. Repairs involve lifting loose tiles, clearing the old mortar and re-bedding them securely.
Gable end and valley repairs
Gable ends take the full force of the weather and can suffer from failed mortar, loose bargeboards and damaged verge tiles. Valleys, the internal channels where two roof slopes meet, carry a large amount of water, so a blocked or damaged valley can cause a serious leak. Both need careful work to get right.
Leaks that aren't what they seem
Not every damp patch is a roof leak. Condensation in a poorly ventilated loft can soak insulation and drip from nails and timbers, especially in winter. Leaking plumbing, blocked gutters overflowing against the wall and failed render can all look like roof problems from inside. Part of an honest roof repair is ruling these out, so you only pay for the work that actually solves the problem.
Repairs on older and period properties
Kent has a large number of older homes, from Victorian terraces in the Medway towns to cottages and farmhouses in the countryside around Ashford and the Marsh. Repairing these roofs well often means sourcing tiles or slates that match the originals, including reclaimed materials, and working in a way that respects how the roof was first built. A patch of bright new tiles on a weathered old roof stands out; a careful match doesn't.
Checking your roof from the ground
You don't need to climb a ladder to spot many roof problems. From the garden or street, look for tiles or slates that sit out of line, gaps where a tile is missing, ridge tiles that look uneven, and pieces of tile or mortar on the ground or in the gutters. Binoculars help. Inside, check the loft on a bright day for chinks of light and after rain for damp timbers or stained insulation.
When is a repair no longer enough?
If the roof has widespread slipped tiles, sagging, rotten battens across large areas, or has been patched repeatedly, a repair may only be buying time. We'll tell you honestly if we think a replacement makes more sense, and equally, if the roof has plenty of life left in it with a targeted repair.
Why Alliance
Why Kent Homeowners Choose Us for Roof Repairs
Alliance Roofing and Property Maintenance is a family-run business founded by Perrin Harber, who has worked in the trade since the age of 11 alongside his dad. With 18 years of hands-on experience, Perrin still works side by side with his dad, supported by a couple of regular leads, and can bring together a larger team when a job calls for it.
When you contact us about roof repairs, you deal with the people who actually do the work. Reviewers regularly describe the team as friendly, honest, polite and tidy, with fair prices and no hard sell. Every job is priced individually, warranty terms vary by the work carried out, and we hold public liability insurance. We're open 24 hours a day, listed on Checkatrade and Bark, and rated 9.56/10 on Checkatrade.
FAQs
Roof Repairs: Your Questions Answered
How much does a roof repair cost in Kent?+
Every repair is priced individually based on the work required. After looking at the roof we'll give you a clear, no-nonsense quote.
How long does a typical roof repair take?+
Many straightforward repairs such as replacing tiles or repointing are completed in a day or less, but it depends on the size and access. We'll tell you the expected timescale when we quote.
Can you repair my roof rather than replace it?+
Often, yes. We'll give you honest advice on whether a repair will do the job or whether replacement genuinely makes more sense.
How quickly can you come and look at my roof?+
Customers regularly mention our speedy response, sometimes coming round the same day. For emergencies, our typical response time is within 2 hours.
Do you take a deposit?+
For jobs over roughly £1,000, we ask for a 50% deposit. Smaller jobs don't require one.
What warranty do I get?+
Warranty terms vary depending on the work carried out. We'll explain the warranty that applies to your job when we quote.
Are you insured?+
Yes. We hold public liability insurance.
Are you available for emergencies?+
Yes. We operate 24 hours a day, and our typical emergency response time is within 2 hours.
Which areas of Kent do you cover?+
We're based at TN27 9JB and cover Kent, including Ashford, Canterbury, Herne Bay, Rochester, Strood, Gillingham, Chatham, Gravesend and Romney Marsh.
Still have a question? Contact us or return to the homepage.
Get your roof repairs sorted properly
Honest advice, a clear quote and no hard sell. Rated 9.56/10 on Checkatrade, insured, open 24 hours.